PDA

View Full Version : Automatic tool messuring



PCSM-CNC
01-08-2018, 09:46 AM
Hello at all.

I changed software to TNG too.
Since the changing my z axis moves up to top limitswitch with max speed.
Thats nerv bad cause two of my switches are broken cause of this :-(
I tryed many parameters in settings but nothing works. If i set z axis to reverse, the z moves down an than direction messuring sensor.
issue one: I want that first axis x and y move to sensors koordinates and then the z.
issue two: messuring work surface is working wit not reverse z axis. If i set z reverse, messuring work surface dont work...

How to set parameters for correct working both kinds of messuring?

I use the same inputpin for both messuring sequenzes.

Regards
Alex from germany

PCSM-CNC
01-09-2018, 09:26 AM
Solved.

I resettet settings and set parameters for Motors and directions again.
Now its working.

But somebody found the funktion for messuring the workposition x + y axis?
There is only the surfacemessuring...