PDA

View Full Version : Omni 1325 with Syntec controller / Vcarve pro



djcregan
07-28-2017, 11:25 AM
Hi All
I was wondering if anyone has experience of modifying the post processor to turn on and turn off the Air blower and vaccum. I think it may have been discussed before but couldn't find anything on search.

Thanks in anticipation.

gfacer2
07-28-2017, 11:30 AM
If the controller is set up to turn them off with m codes then it is easy. If its not, then the syntec plc ladder needs editing and I've yet to figure that out. I got an editor from syntec but it doesn't recognize the file. I've just been curious so I haven't spent a lot of time on it.

You should be able to test m codes from MDI mode.



Sent from my LG-D852 using Tapatalk

gfacer2
07-28-2017, 11:31 AM
Oh, I did get omni to edit the ladder for me at the beginning to do this (vacuum and dust via my codes) as it was in my specs but I haven't succeeded on my own yet.

Sent from my LG-D852 using Tapatalk

djcregan
07-28-2017, 11:32 AM
Hi Graham
Yes Ive had a quick try with the MDI but I may be using wrong codes, I tried M7, M8, M9?