PDA

View Full Version : Post processor for grbl



kermit582
04-14-2017, 05:28 AM
Hi guys i am using grbl for a cnc plasma table i have been using sketchucam and it works well but there are some plasma functions it does not have (leadins, leadouts, peirce height etc.) so i down loaded sheetcam it has all the stuff i need but not sure which ppst to use for grbl? Or is there one in the list that will work at all? Or maybe there is some other way to make it work?

kermit582
09-30-2017, 08:29 AM
Hi guys i am using grbl for a cnc plasma table i have been using sketchucam and it works well but there are some plasma functions it does not have (leadins, leadouts, peirce height etc.) so i down loaded sheetcam it has all the stuff i need but not sure which ppst to use for grbl? Or is there one in the list that will work at all? Or maybe there is some other way to make it work? nobody know anything about this?

Bubba
09-30-2017, 08:40 AM
If you can't find one, I suggest you write it up on the Sheetcam forum. Les has always been responsive to providing new posts or suggestions on which one to use.