PDA

View Full Version : 4th axis post processor and set-up on 4896ATC



Hypotenuse
01-15-2017, 10:47 PM
Just curious if anyone can comment on their set-up if using a 4th axis. I finally got to doing a dry run tonight but not successfully.
When I talked to SS help they told me I didn't need a designated post processor and that it's works better oriented along the x-axis.
I tried using a file from both x and y positions but the indexer wasn't turning at all.
It also just cut like a non-indexed file.
I will call them again tomorrow all the same.