PDA

View Full Version : toolpath cannot be created because of unmatched feature or Esprit 2014



Midgetracer31
11-08-2016, 02:36 PM
Trying to do a simple round punch that has a diameter of .748 with a .052 dia tab on it. I want to do a rough-skim-cutoff and I keep getting the "toolpath cannot be created because of unmatched feature or" I have had this before when doing die sections with tight radii in corners. If you tell it to do rough-skim it does not error, but of course thats worthless as its impossible to make a punch like that. Wasted almost the entire day beating my head against the wall......

I attached a .dxf so you can see the shape, I altered the inside radii to as much as .012 trying to get it to go.