PDA

View Full Version : Chucking



tcovington
07-27-2016, 11:25 AM
Is there a feature in ESPRIT that you can define od or id chucking? I have an operator that is wanting to switch how he is holding a part which currently is 3 jaw od to a 3jaw id but I'm not sure if this is a machine specific thing to get the program to run or if I need to switch something within ESPRIT. Thank you for any guidance!

rbest42
07-30-2016, 08:48 PM
In the machine setup you can choose the way you chuck. But you will probably have to change the setting on the machine to switch from OD to ID chucking.