PDA

View Full Version : What motors with shopmaster



mysterious
02-23-2004, 04:10 PM
I plan on getting a shopmaster and turning it into CNC. My knowledge is limited in making my own control box so I was thinking of getting a control box from DenverCNC (http://www.denvercnc.com/controller.htm) , which is based on Xylotex control boards, and was wondering if the motor 344-1053-SB (http://sanyo-denki-online.com/nema34.htm) would be a good choice. Shopmaster's kit only uses 500oz motors because they have a 3:1 reduction. Would it be better to get the 720 motors if I wanted more speed or which motors would be faster? Also which ones would cause less heat? Would these motors even work with the control box? Any thoughts appreciated.