PDA

View Full Version : Fusion360 Post Processor for MACH3 Plasma



bc201081
06-26-2016, 04:48 AM
I have just started using Fusion360 my question is, Is there is a Fusion360 postprocessor for Mach3 Plasma?

I'm trying to use the Waterjet/Laser/Plasma Contour in CAM but when I try to post process using the generic Mach3Mill I get this error.

"Error: Waterjet, laser, and plasma cutting toolpath is not supported by the post configuration."

daniellyall
06-26-2016, 07:30 AM
ask on the forum you will need a custom post