PDA

View Full Version : Need Help! DDCM6V5.0 disconnects randomly with mach3



kitowtech
06-25-2016, 02:02 PM
Hello all!

I have the DDCM6v5.0 breakout board connected and running successfully on mach3. However, after running many job for any random amount of time (5-120 minutes) this board stops communicating with mach3.. and I mean just flat out stops dead in its pathing. This is where I need to unplug the board, repower, and home.. very tiring!

I also get a good chance of being disconnected when I push the reset button in mach3..

I'm only sticking with this board because of its 6 axis capabilities so if anyone knows the answer to this problem I would give you a virtual high five!

Many thanks. :)

alien2108
07-21-2016, 02:36 PM
Hello!

We have exactly same problem, this seems to be a common issue with this chinese **ap.