PDA

View Full Version : fanuc 11m tool table



Carter
05-10-2016, 03:00 PM
i have a nomura bn110sr with a fanuc 11m control.
the tool changer seems to be wanting to work, but will not. the tool readout on the pendant shows T00 in spindle and T00 in pot. the machine does have an alarm for T00 but it is not occurring which leads me to believe that there may be something missing in communication in the machine itself.

can someone point me in the right direction as to where the data is stored for what tool is in the spindle and what tool is in the atc pot? i'm thinking that it was in the nc/pc area but i dont have the manual and dont remember.

thank you
c