PDA

View Full Version : 3D CUTTING BITS OR V CARVE BITS



tdoz
02-12-2016, 12:18 PM
Hello everyone,

In the absence of a carving bit can I use a 60 degree v bit?

If so, how do I set up stepover parameter.

I use RhinoCam.

Thank you.

Tolu.

awerby
02-12-2016, 04:04 PM
No; it's not the same thing at all. You can use a ball-nose endmill, but the ends of those V-carving bits are sharp, so you'd get lines all over your carving.