PDA

View Full Version : 4.0 updates ?



bobleecnc
02-04-2004, 07:06 PM
Hi Eric (AKA) Balsaman do you know if there have been any further releases of turbocnc version 4 since the original beta?
I was one of the original beta testers for ver.4 but had to have
Dave take me off the email list because I was getting duplicates of all my email and it was fillimg up my inbox . Since then I've tried to email Dave and have gotten no response ,do you have any news on the progress of the constant contouring feature thats rummored?

Bob

balsaman
02-04-2004, 07:40 PM
Yes there have been several betas released. It should be very soon that we see a version 4 for the general public. It's very good but no CVC so far. I think you will need to wait for version 4.1 for that. CVC was not sheduled for this release, nor have they been writing any CVC code thus far.

Eric

bobleecnc
02-04-2004, 07:48 PM
Thanks Eric for the reply is there any way I can get those new beta releases or at least the latest one. I PM'ed Dave but I'm not sure if He's monitoring right now.

Bob.