PDA

View Full Version : Is sheetcam still supported



ukracer
10-07-2015, 06:15 AM
Is sheetcam still supported as I cant get activated for the sheetcam forum.

I am trying to find out if sheetcam is what I need to run a torchmate table and electronics as I cant get my head round what software is needed or where Mach 3 comes into the equation.


Regards Andy T

Bubba
10-07-2015, 08:01 AM
Les has been active in the mailing list and seems to be alive and well.

Which forum are you trying to get activated on??? There is the mail list on yahoo and the stand alone one at:
sheetcam.com :: Index (http://www.forum.sheetcam.com)

ukracer
10-07-2015, 10:09 AM
Les has been active in the mailing list and seems to be alive and well.

Which forum are you trying to get activated on??? There is the mail list on yahoo and the stand alone one at:
sheetcam.com :: Index (http://www.forum.sheetcam.com)

standalone one mate...