PDA

View Full Version : help



peterlou41
01-29-2004, 03:34 PM
Hello My name Pierre R. for Montreal,Quebec,Canada

I would like to no if is anyone got a list of material what i ned to converst 9x20 lathe to CNC. Can you send me the specs of the equipment and the list of material i ned to finalize my CNC Lathe.
(software / hardware, resistance power supply ??)

Thank you very much in advance for the attention that you will provide me.

peterlou@aei.ca

:confused:

Snel
01-29-2004, 05:27 PM
Peter,

Check out this site: www.homecnc.info. Very informative site. The links on the site also takes you to software and control sites.
You should be able to build your own control from this site.
Not too much info on a lathe but useful information in general.
Good luck !
Dave