View Full Version : Need help for arduino programming

04-25-2015, 01:21 PM
who can help me to make the ( software ,firmware) of fab@home 3d printer compatible with :
-easy driver
-nema motor
knowing that the software and the source code is available at the following address:

Fab@Home:Model 1 Firmware - Fab @ Home (http://www.fabathome.org/wiki/index.php?title=Fab%40Home:Model_1_Firmware)

Model 2 Software - Fab @ Home (http://www.fabathome.org/wiki/index.php?title=Fab%40Home:Software)

Fab@Home:Electronics - Fab @ Home (http://www.fabathome.org/wiki/index.php?title=Fab%40Home:Electronics)

Thank you

11-14-2015, 12:39 AM
Look up minibloq in your browser and you will find a free program that does aduino graphical programming.