PDA

View Full Version : New to CNC (Wilmington NC Area)



atgordon
04-14-2015, 11:58 AM
Experienced machinist, just acquired a Klondia FV1 CNC with Dynapath Delta 20 controller. I can run machine in jog mode, but moving beyond that is a challenge. Anyone in the Wilmington/Jacksonville area willing to help a newby out?

I have the Dynapath manuals, and have MasterCam X Mill loaded on the Mill connected computer. The mill is setup to receive programs from the computer and can take (so I'm told) drip-feed, if needed.