PDA

View Full Version : Fanuc 6m



heavydiver
02-10-2015, 02:24 PM
how do i put in diameter and tool lenght in the system.
i got a roku-roku milling machine and the book for it.
i cant figure it out how to do this
for exempel
tool nr 1 lenght 120mm and diameter 22mm
how is the proceed to do this
thankful for help
peter

bertus.nl
02-14-2015, 05:30 PM
l.s

maybe this wil help

268864

if everything goes right you see a picture above of youre tool offset screen

the count goes from 1 to 60 or someting

I use 1 to 30 for lenght offset , and 31 to 60 for diameter

In program that looks like this

O5000
G90 G17 G80 G49 G40
G91 G28 Z0
G90
M01
N1 M6 T1
G90 G00 G40 G54
G43 H1 D31 G0 X37. Y18.5 Z50. S2000 M3 ( H1 for length offset 1 ) (D31 for diameter "only get active with G41 G42 )
X37. Y18.5 Z10.
Z2.
G1 Z-4.5 F33
enz...

i hope this helps you


greetings bertus.nl