PDA

View Full Version : Need Help! How to calibrate table?



ratpack
01-12-2015, 01:27 PM
When I cut straith lines on X or Y the cut is fine ( nice cut no jageth edges ) but when I cut curves and angels my cut is very jaget almost like a saw tooth.
How do I correct this?

nephroneis
01-12-2015, 05:36 PM
Try reducing your speed on the curved cuts and see if the problem goes away. It could be whip in the axis movements.

ione
02-10-2015, 09:49 PM
Hi rat,
Think it must be your drawings on dxf try a different resolution .