PDA

View Full Version : new Dynatorch software issue



kyp
10-28-2014, 11:29 PM
Hi guys,

I have recently updated the Dynatorch software (I'm running SuperB) to the version that has been sent out by them in the email.
I have one big issue with it. After pausing the job the job does not resume the run. I have to cancel the run and go to the line to continue.
Am I the only one?

The minor is that software integrated plasma control doesn't work with plasma.

PS: if any dynatorch reps can reply that will be great.

Lasersolution
05-31-2015, 12:14 AM
https://www.youtube.com/watch?v=Tj7yl5TdwsI&list=PLuKckWA-K7NUxFnm9byPS9nyVywMxYjmw&index=27