PDA

View Full Version : howdy folks I need some advice



TheRealDingus
10-20-2014, 06:33 AM
I have a maxNC and am replacing the blown PSU and controller with a gecko g540 controller. The wire setup is the basic red, green, blue, black AND there is a (to the motor) ground and the end wires for the coils are all connected to a white wire so I have 6 wires at the end of the cable. That means I have the 4 basic wires plus 2. Where do those two go on the 9 pin connector? And I have tried to post an image but I just get the box that wont close.