PDA

View Full Version : Problem Sheetcam gcode generation lacking



jerrysim
06-01-2014, 03:43 PM
I am in evaluation mode of sheetcam which seems to me the best out of all I have looked at for the last 2 months. Recently tried to use a pocket operation of the letter "J" and the letter came out ok, but around the J was left un-machined wood which i seen in the sheetcam image but not sure why it seems to have incomplete gcode. i am very new to CNC and don't know enough about g code to modify it. It first seemed that it was mach3 producing this but realized later that it was processed like this thru sheetcam. any body know if its just a set up issue or ?

metalfixer
06-02-2014, 04:56 AM
It's been a long time since I've used the evaluation mode of Sheetcam, but I think it will only produce a limited number of lines of Gcode, just to check your machine's setup.