PDA

View Full Version : Need Help! Aftermarket Torch Height Control (THC) Purchase Options (June, 2014)



keldanmedia
05-28-2014, 02:30 PM
Great forum!

I'm considering THC purchase options.

I'm running Sheetcam/Mach 3 with an Everlast 60C Plasma w/machine torch. The following products seem to be used a lot by the DIY CNC community and all three companies have very good overall reputations (customer service, expertise, etc). I only know basic electronics and would prefer not splicing plasma cutter internal wiring (however i realize this is probably not an option based on my research). I do like the Everlast 60C but the CNC Port seems to be less than advertised due to buffered divided arc volt options but the Torch On/Torch Ok do work, however.

I expect to upgrade my BOB (probably G540) Are there additional THC options I should look at? Your experience? Expectation versus results?


LCTHC $275 and up from CANDCNC
http://www.candcnc.com/LCTHC.html

PROMA THC $300 from EAGLE PLASMA
CNC Plasma Tables | CNC Kits | CNC Ganrty Systems (http://www.eagleplasma.com/thc)

Stand Alone Plasma THC Controller $805.35 from CNC4PC
CNC4PC (http://www.cnc4pc.com/Store/osc/product_info.php?cPath=70&products_id=616)


Thanks!

Steve