PDA

View Full Version : Please Help! - DynaCNC 4000 Blowing Z Axis Fuses



Beagle Rancher
05-27-2014, 12:11 PM
I have a very large DynaCNC table with a Z axis problem. As soon as I reset Mach 3, the control box kicks in, then out and blows the 10 amp mini auto style fuse. It just started doing this and happens as soon as the reset is pressed on Mach 3. Any ideas on what to check or how to go about troubleshooting would be greatly appreciated. Thanks in advance.

Thanks,

Brian

lowpull
06-23-2014, 11:27 PM
try swapping gecko's between z and x or y and see if the problem follows the gecko.