PDA

View Full Version : Drill bit holders for Tool Changer?



coltac
04-01-2014, 09:51 PM
Hello everyone. I just got a little Rhino cnc lathe, with a tool changer and Fanuc 6t controller. I am in need of some way to hold drill bits and a center drill on the turret. The holes on the turret are .750" in diameter. There is a set screw for each one. I was hoping one of you all knowing CNC men would know of what kind of collets, or bit holders i will need. Ill include a picture of the turret. Thanks for your time!

230648

rowbare
04-02-2014, 01:38 PM
Since the holes are 3/4" diameter perhaps TTS holders would do the job for you.

Tormach Tooling System® | Tormach LLC providers of personal small CNC machines, CNC tooling, and many more CNC items. (http://www.tormach.com/product_tts.html)

bob