PDA

View Full Version : Where's the ViaCAD/Shark forum gone?



blowlamp
01-20-2014, 04:48 AM
The title says it all.

We had a forum here for a week or so and now it's gone - why is that?


Martin.

TOTALLYRC
01-20-2014, 05:08 AM
Beats me, I was enjoying it since I have been using Viacad for years.

Bob La Londe
01-20-2014, 11:34 AM
I really enjoyed it because there seemed to be a better free flow than on the VC forums. That and faster responses from those people involved. You can't access the VC forums until you have already purchased VC, so that alone is a good arguement for a forum that is not controlled and moderated by the manufacturer.

Bob La Londe
01-20-2014, 11:41 AM
Here is the original thread where I asked for it. Maybe if a few people ask WHY!?

http://www.cnczone.com/forums/suggestions_cnczone_com_site/206072-viacad_-_shark_-_forum_request.html

blowlamp
01-20-2014, 11:49 AM
Yeah, come on Admin - the forum attracted users right from the start!
Why kill it off before it got going?

Martin.

Bob La Londe
01-20-2014, 12:08 PM
I think it would get more attention in the request forum.

cncadmin
01-20-2014, 12:42 PM
my bad all fixed.

blowlamp
01-20-2014, 12:54 PM
Thank you very much, Paul.


Martin.