PDA

View Full Version : Questions about the IH Mill CNC Conversion



Bird_E
05-12-2006, 01:49 PM
Can anyone answer a few questions I have about the IH Mill CNC Conversion?

1. On the Z Axis, does the ball screw get supported on the lower end? If so does it use the exsisting bearing from the original hand crank assembly?

2. Does anyone know what kind (manufacture) of servo motors the CNC conversion uses?

3. What is the belt reduction ratio for the X Y & Z?

4. I'm REALLY interested in plans or a kit for the BELT Drive conversion. Has anyone seen this yet?

Thanks in advance!
Bob

KEYTEEM
05-15-2006, 12:11 PM
did you see whats available from aaron at industrial hobbies?
he sells kits - i don't think he sells plans