PDA

View Full Version : Master5 Setup



boxwood
11-04-2003, 08:35 PM
Hi All

anyone have experience setting up Master5 I am trying to setup the demo for some test. I have the pin configuration and and steps per inch set and it will jog correctly, In the motor setup screen I have set inches per second to .475 on all axis and it
jogs like it should. but when I run the calibration for the motors or a program this setting is way to fast I end up at about .32 in/sec. Why can I jog dependably at the faster speed but it will not run a program at the same speed, I only have a 200mhz 128mb pc could this be a problem. any input would be welcome

Ray