PDA

View Full Version : Need Help! nema 34 wiring ?



Inverted CNC
09-26-2013, 12:45 AM
I'm getting ready to kick off my pro2448 build but I need some help with cabinet the wiring.

Over time I slowly acquired the geckos, motherboard, break out board and enclosure. I had to do it this way as my budget allowed rather than waiting and purchasing the complete kit from cncrp.

Could someone out there post a couple pictures of their electronic setup inside the cabinet ?

I've got all the documentation but as they say a picture(or two or three) is worth a thousand words!

Thanks in advance:)

ahren
09-27-2013, 01:15 PM
Hi Eric,

Here's a picture of how we wire things in our electronics panels. Hopefully that gets you going!

Best regards,

Ahren
CNCRouterParts (http://www.cncrouterparts.com)