PDA

View Full Version : Confused on Deskcnc setup



ozturbo
03-12-2006, 04:28 PM
I have a quick question. Can stepper motors be wired directly to the deskcnc board or do i need to also have a driver board like the Xylotex.

Kookaburra
03-12-2006, 05:52 PM
You will need a driver board as the deskcnc board only outputs step and direction for a stepper driver and will not drive the motors directly

ozturbo
03-12-2006, 06:03 PM
Thanks, Desk CNC's documentation was confusing.