PDA

View Full Version : 3D Mill Along Curve problem



declanhalpin
05-29-2013, 02:27 PM
Hi all,

For some reason, when I designate a curve to be followed, the cutter is plunged so it cuts under the curve.... How can I have the cutter follow the curve with it's tip?

dh

Dan B
05-29-2013, 03:53 PM
Ball nose tool?

declanhalpin
05-29-2013, 03:58 PM
Flat with radiused corners, but the same thing happens with ball-nose. I would like to be able to drive a ballnose along a curve (at tool tip) also....

williamsmotower
05-29-2013, 07:36 PM
Make sure "tip" is checked under 2d or 3d operations in settings