PDA

View Full Version : General Numeric manual needed



Scott Pancheau
04-01-2013, 09:50 AM
Purchased an old Powerhawk bed mill. It has a General Numeric series 2 or 11 ? controller. Control seems operational but I need an operator manual for it. Willing to pay for a manual. Tried searching on google with no luck. Thanks for any help or suggestions.

scott

tecnc1
04-02-2013, 09:32 PM
Can't help with a manual, but General Numeric preceded the Fanuc 10 and 11 controls, may have been the same. Depending on what you're looking for information-wise. Might try finding a copy of those.

Scott Pancheau
04-03-2013, 09:33 AM
Thanks for the suggestion, I will do some more searching. It does have all Fanuc drives so that would make sense.