PDA

View Full Version : Turbocnc hit the G-spot fast enough?



praetor
02-02-2006, 05:27 PM
I've purchased an old penPC tablet, actually it's the fujitsu stylistic 500 with windows 98 and turbocnc installed, from Juan Gelt, www.cnc-g-spot.com, I read some where on this site, bit-tech.net; under hombrew cnc, that turbocnc was too slow, (he claims a piece he made took four hours to make), Is this true?

Oldmanandhistoy
03-03-2006, 03:38 PM
I have used Turbocnc for quite a while now and have no complaints where speed is concerned.

I do not think his slow speed would be down to Turbocnc, more likely how it has been set up or the PC it is being run on and possibly the cnc machine being used or a combination.

Hope this helps, John