PDA

View Full Version : Quick start help!!



jetstuff
01-29-2006, 04:57 AM
Hello gents, I've just finished building my first axis board and PSU.... I need a quick intro and file to test system...I only have Turbocnc available on the PC... is there a quick, short program or way of testing one axis.... many thanks
John

ger21
01-29-2006, 07:13 AM
You can use MDI mode and just type G1 commands.

G1 X10
G1 X1
G1 X10
.......

jetstuff
01-29-2006, 12:22 PM
many thanks...IT WORKS..... clever stuff thum thar puters! :D

Any way to enable pin 14 low via the software...It's been a long time since I found my way around DOS based stuff.
john