PDA

View Full Version : My Second Machine Design



ljoe1969
01-19-2006, 11:19 AM
Hi.

I just completed my second machine design after countless revisions.

it will be made from 1" square tubing for the frame and 3/4" mdf for the rest.

the cut area is about 19" x 30" x 3"

here are some drawings that you all can look at and give me some feedback before i start building.

jmytyk
01-19-2006, 10:31 PM
I like the improvement on the X-Axis, It looks to be Angle iron backing up the flex of the pipe?

spalm
01-19-2006, 11:35 PM
Hard for me to tell. Is it square channel (or angle or plate) backing the X up? Why not do it for the Y also?

I think I see square channel supporting the X end plates, not a bad idea but this is not where you need to worry about flex.

Steve

ljoe1969
01-20-2006, 09:16 AM
Here is a drawing of the x axis support rail.

ljoe1969
01-20-2006, 11:06 AM
and here is a drawing of the y axis rail support assembly

pminmo
01-20-2006, 05:32 PM
I made a pdf of the full view for those who can't see a dxf file: