PDA

View Full Version : Fanuc 18T on Ikegai TU-15



inmoteng
07-05-2012, 05:01 PM
Hello All,

We have a 1994 Ikegai TU-15 turning center with a Fanuc 18T control. We just lost all the parameters as I think the battery for the control died. Does anyone have these parameters and information on where to get/how to replace the battery?

Thanks!
Ed

QuickDraw
07-08-2012, 04:20 PM
I work on 3 of these, I'll see what I can find out.

Whoops... ours are OT-9, not sure if you can use the basic parameters?

moonfixer
03-11-2013, 04:51 PM
Hi Ed,
I'm Tom. Did you get your Ikegai back up and running? Does yours have a C axis/live tooling? If so, can you rigid tap w/ the live tooling and what is the code? Mine is an TUR15 w/ Fanuc 18-T control.