PDA

View Full Version : Looking for a GRBL forum. Where ?



someguy123
07-02-2012, 01:49 PM
I'm looking for a place to discuss a bunch of GRBL things. Like a community forum.

Where would I find it ?

Are there any GRBL people here ?

doorknob
07-02-2012, 03:33 PM
The GRBL discussions that I have seen here have been scattered in various places.

One place that might be good would be Open Source Controller Boards - CNCzone.com-The Largest Machinist Community on the net! (http://www.cnczone.com/forums/open_source_controller_boards/) (but there hasn't been much activity there).

(even though GRBL is software/firmware and not actually an open source controller board, when running on an arduino board it sort of is)

someguy123
07-02-2012, 04:27 PM
Thanks.

saimgee123
03-23-2013, 06:40 AM
Yes you can also discus about it in this forum and check this forum.
shapeoko.com/forum/viewforum.php?f=3
You can also discuss here about the all type of GRBL topics.