PDA

View Full Version : Need Help! What is going on?



Tram
06-27-2012, 03:47 PM
Ok guys..

I've got a file I've been cutting for a long time.

Was cutting yesterday and my cuts are off.

I have the same shapes being cut, one on top of another - sorta mirror imaged.

The top cut is coming out fine. The bottom cut is getting the shape correct, but is not traveling the full length of the cut and when it finishes cutting, it is finishing about .5-1" behind where it started.

Foamlinx machine.. Foamworks software.

Anyone?


---
I am here: http://tapatalk.com/map.php?k1umvr

ChuckC
07-02-2012, 02:12 PM
I really don't know very well as I'm much newer at this than you, but it sounds like you are loosing steps for some reason. Everything moving smoothly when power is off, etc?

RCWorks.com
11-24-2012, 03:42 PM
Is this the foamlinx made from stamped steel and rods?

If so it's binding and losing steps...


Ok guys..

I've got a file I've been cutting for a long time.

Was cutting yesterday and my cuts are off.

I have the same shapes being cut, one on top of another - sorta mirror imaged.

The top cut is coming out fine. The bottom cut is getting the shape correct, but is not traveling the full length of the cut and when it finishes cutting, it is finishing about .5-1" behind where it started.

Foamlinx machine.. Foamworks software.

Anyone?


---
I am here: http://tapatalk.com/map.php?k1umvr