PDA

View Full Version : Please help with floating z



duramaxer
06-13-2012, 08:22 PM
I have a question regarding the z drive I set it up on mach3 and sheetcam to
where when it goes down and hits the switch it goes to home and when it
comes up its in the negative but I'm not sure how to configure sheet.
Sheetcam I did te v button to 0.3 but whe it writes the gcode it writes the
z as a positive can you please show me how toconfigure this .... Also when I
click the reference t only on motor on the y moves the other one doesn't or
it will move in the opposite direction it only does that when I hit ref if
I'm jogging normal it moves normal .... Thanks I'm running the mp100 thc post processor