PDA

View Full Version : Software change request



widgitmaster
11-25-2005, 03:18 PM
Using Mach3.


I'm not sure if I'm doing this right, but when I go to zero a tool and set the offsets for my part location, I have to click the Jog % way down, sneak up on my part, then click 30+ time to increase the jog to do something esleware!

Could you please place a max button or a key combo like <SHIFT><CLICK> for the jog, that would pop it back to 100%?

( If I only had a Manual Pulse Generator & a pendant! :tired: )

Thank you,

Eric A. Arnold

ger21
11-25-2005, 07:04 PM
Hold down shift while jogging for fast jog. :) Set your slow jog to something like 5%, hold down shift and jog down close. Then use the slow jog to get your zero. Hold down shift to jog quickly back up.

widgitmaster
11-25-2005, 09:38 PM
Thanks for the reply Gerry, I'll try that!

Eric