PDA

View Full Version : ViperXZ & ViperX2 set up



gio666
04-01-2012, 05:35 PM
Start with motor side upright

http://i40.tinypic.com/2guxrap.jpg

gio666
04-01-2012, 05:37 PM
Slide in 2 Y rails

http://i42.tinypic.com/2usd2sp.jpg

gio666
04-01-2012, 05:39 PM
Leave rails a little loose

http://i39.tinypic.com/217gci.jpg

gio666
04-01-2012, 05:40 PM
Y axis assembly

http://i42.tinypic.com/nxkqxc.jpg

gio666
04-01-2012, 05:42 PM
Slide rails into bearing, make sure to have 4 bolt holes on bearing house facing forward

http://i40.tinypic.com/k4giyt.jpg

gio666
04-01-2012, 05:44 PM
Slide coupling through hole on upright

http://i43.tinypic.com/1fzsys.jpg

gio666
04-01-2012, 05:45 PM
Free end bearing house

http://i39.tinypic.com/25hlreu.jpg

gio666
04-01-2012, 05:47 PM
Put free end bearing house on bearing

http://i41.tinypic.com/302sao5.jpg

gio666
04-01-2012, 05:50 PM
Put other side upright onto rails , tighten but leave a little loose m6-16

http://i40.tinypic.com/dcp4z.jpg

gio666
04-01-2012, 05:51 PM
http://i41.tinypic.com/2n0u5fm.jpg

gio666
04-01-2012, 07:52 PM
Install 4 X bearing houses M8-16 bolts

http://i41.tinypic.com/e7x6zd.jpg

gio666
04-01-2012, 07:53 PM
http://i41.tinypic.com/vhuona.jpg

gio666
04-03-2012, 08:41 PM
Slide crossmember into uprights, remember to add weld nuts in middle of the 3 row

http://i39.tinypic.com/2zss9xh.jpg

gio666
04-03-2012, 08:44 PM
http://i41.tinypic.com/9gzx1f.jpg

gio666
04-03-2012, 08:46 PM
Again remember to put in weld nuts

http://i40.tinypic.com/2ajpfe0.jpg

gio666
04-03-2012, 08:47 PM
Tighten down rails and crossmember tight,will not have to touch again but still leave rail bearing blocks a little loose

http://i40.tinypic.com/6z0i6w.jpg

gio666
05-03-2012, 07:29 AM
I will try to finish instructions this week for people asking