PDA

View Full Version : RFQ for Plasma Laser Waterjet



z28
03-01-2012, 12:01 AM
http://i1163.photobucket.com/albums/q556/Shanejulie/plasmatableslat.jpg

I need quantity 2 of these parts cut out. They are slats that will hold 1/8 table rails for a cnc plasma table that I am building.

They can be plasma, waterjet, or laser cut. I will provide a DXF file.

The measurements are 32.5" long X 3.88" tall

Thickness can be any where from 8 - 10 gauge steel. Im not to picky on these they can be cut from whatever scrap you have laying around in this range. No finishing is needed.

Include shipping to Utah zip code 84043 in quote.

I can pay via paypal. I would like to have them done by 03/10/12

Thanks,
Shane

jimcolt
03-01-2012, 07:42 AM
These parts, cut from 10 gauge steel would be $12.49 each. Shipping from NH to Utah is estimated at $18.

You can probably find someone local that can do them with lower shipping costs. Because of the length....the shipping is high.


Jim Colt




http://i1163.photobucket.com/albums/q556/Shanejulie/plasmatableslat.jpg

I need quantity 2 of these parts cut out. They are slats that will hold 1/8 table rails for a cnc plasma table that I am building.

They can be plasma, waterjet, or laser cut. I will provide a DXF file.

The measurements are 32.5" long X 3.88" tall

Thickness can be any where from 8 - 10 gauge steel. Im not to picky on these they can be cut from whatever scrap you have laying around in this range. No finishing is needed.

Include shipping to Utah zip code 84043 in quote.

I can pay via paypal. I would like to have them done by 03/10/12

Thanks,
Shane

z28
03-01-2012, 10:02 AM
Jim, thanks. Offer accepted I sent you a pm. This rfq is now closed.