PDA

View Full Version : Need Help! G-Code for 2D Sign Cutting



graphpix
02-25-2012, 11:08 AM
Anybody knows easy way to create g-codes automatically for 2D foam letters?

I tried first my friends lazycam software, it's very good at showing on screen and automatically create toolpath for hot wire that i need. But after i post g-code to mach3, i see inner shapes not looking. Tried two other dxf and nothing changed.

After then i tried deskcnc but it's difficult to set "Start/Depart" points manually all the time.

So i need your advice for easy and clean way to make this.