PDA

View Full Version : Need Help! Looking for a chamfer/engraving bit with specific deimensions..



Navatek
02-24-2012, 09:32 PM
Hi guys... I'm looking for a chamfer endmill type bit that I can use to do cleanup of 90 degree angled surfaces. I want to come in at an exact 45degree angle in the x, y, and z axis and walk the bit along the 3 joints to clean up anything leftover. This would mean that I need a chamfer bit with an 70.52 degree chamfer. I can't seem to find anything close to that. I can only find 60, 82 or 90 degree bits out there. Do any of you know where to find such a bit? Attached some pics cause my description may not make sense...

http://www.unstupid.com/myimages/chamferbit.jpg
http://www.unstupid.com/myimages/chamferbit2.jpg

Thanks!

Bada Bing
02-24-2012, 11:22 PM
AB Tools Inc (http://www.abtoolsinc.com/)

will make it to your specs.

LMT Onsrud LP
02-25-2012, 09:32 AM
Good morning,

My name is Fred and I work for LMT Onsrud.

I see what you are trying to accomplish, but I don't believe we carry something along these lines either as a standard tool. If it helps, I can have someone in our tech support contact you on Monday to discuss options from an informational standpoint or where to find such a bit.

Or feel free to contact us directly at 800-234-1560. You may ask for Bill in tech support.

Fred
Fphillips@onsrud.com