PDA

View Full Version : Need small steel pieces laser cut (not engraved)



Grip_Us
02-18-2012, 01:00 PM
I have three designs each smaller than 1" square that I need laser cut from 22ga steel. Stainless would be my first choice but if a milder steel would be cheaper (by a good magrin) then that would work also. Depending on the cost I would like to get between 200 and 500 of each design cut. I can furnish you with the vector files for the designs. I have also been toying with the idea of aluminum because it would be easier to form/sand.

Example (http://www.gripus.com/Ranger%20Star.htm)

Contact: joe@gripus.com

bravogifts
02-23-2012, 11:51 AM
Hi Joe,

If your project is still open, we're interested in quoting for you.

Please send drawings to hugo@wizmetal.com

Thanks.

-Hugo