PDA

View Full Version : Need Steel Stamp Drawn in MasterCAM x4 for Mill Job



Dezmond
02-05-2012, 11:27 AM
Hey Everyone. I am looking for some help with getting my Makers Stamp drawn up so I can have it milled in O1 Tool steel so I can use it on my knives I am making. I don't have experience in MasterCam but a Shop that is local to me said they could mill it out.

I need it to be 2 sizes. one .75" wide x ??? it works out to be and also 1.5" wide x ??? .

I don't know how to make it raised or to create the tool paths etc... I plan to stamp it on my metal blades (the smaller one) and on my leather sheaths (the bigger one).

I am from Ontario. Any help would be great. Attached is the pdf of the file.

Thanks again.

Dezi

a1cadcam
02-06-2012, 10:40 AM
seems too small for cnc shop to cut directly...
better way might be to reverse cut it in graphite/copper and get it EDM'd

just my thought

jeffrey001
02-06-2012, 12:14 PM
Normally, if you post on the RFQ forum, you will have to pay to get help.


Jeff

diycnc
02-06-2012, 09:45 PM
dxf is a format that mastercam can read.