PDA

View Full Version : Need Help! 4 Axis TB6560 CNC Stepper Motor Driver Board Controller with a GGC usb



RCjunkie
01-19-2012, 10:17 PM
I have a 4 Axis TB6560 CNC Stepper Motor Driver Board Controller.And the motor hook up.
A+
A-
B+
B-
I tryied
A+ as A red
A- as a black
B+ as B white
B- as b green

The motor are on but all that happens the relay clicks

blake374
01-24-2012, 10:21 AM
This might be a shot in the dark but I have always hooked up 4 wires as

black
red
green
blue

vulcom1
01-24-2012, 10:45 AM
If you have an 8 wire motor (23-205-DS8) you are partially correct. The motor has 4 coils and you are connected to each end. Connect the yellow and blue together and also connect orange and brown together. If it does not run then reverse the red and black connections.
Try it. John