PDA

View Full Version : Fulfilled: I'd like to have a single part cut from aluminum



Hirudin
12-18-2011, 04:33 AM
Thank you for your interest. I have accepted a quote and have sent my payment.
I will leave the following information for informational purposes...

Howdy! I would like to have a single part cut by someone. I'm not terribly worried about the tolerances, but it would be cool if it was within about five-thousandths. If that's unrealistic I can amend my expectations.

I designed the part in SolidWorks but it also opens in Rhino.

It's quite simple and I designed it so the majority of it can be cut with a 0.5" endmill. It can be cut from 1.5 x 1 x 9.25" stock. I would like a nice surface finish on it.

Attached are a couple screenshots of the part...

I'm in Albuquerque, NM, USA. I'd like it to be cut from 6061 aluminum. Please let me know how quickly you think you could get it finished.

Thanks!


Oops, the images were wrong, so I replaced them with correct images.

jeffrey001
12-18-2011, 10:36 AM
What about this radius (with arrow)

Would you accept a 1/4 radius also ?

Jeff

Hirudin
12-18-2011, 01:27 PM
What about this radius (with arrow)

Would you accept a 1/4 radius also ?

Jeff
Oh oops... Thanks for pointing that out! I had put a fillet on there in an earlier drawing, but I forgot to put one on in this one.

Yes, a 1/4" (6.5 mm actually) radius is fine.

(I will update the images in the first post.)

Hirudin
12-18-2011, 05:26 PM
I have sent an email to everyone who has replied so far. Thanks!

Pyrokuda
12-19-2011, 01:24 PM
Hello,

I can quote your part.
Please send an IGES or STEP file to briscoe_machining@hotmail.com

Also include what kind of turn around time you are looking for.

Brad

Briscoe Machining LLC
614-282-6862

Hirudin
12-19-2011, 07:08 PM
Hello everyone. Thanks for the replies! I have chosen a company and already sent payment.