PDA

View Full Version : Text that is both raised and V-cut



bsimages
12-10-2011, 06:45 PM
I was experimenting today with text that is both raised and V-cut.
It came out pretty good I think.
I first of all created the V-cut text file without the raised text.
Then I added the raised text to the banner.
I then cut piece out with 1/8 inch tapered ballnose bit with a stepover of 0.005 inch.
I switched to a 45 degree V-bit cut into the raised text...
After a light sanding it left a raised hallo around the V-carved text.
This should make a nice Christmas welcome in our front door!

LouF
12-11-2011, 02:51 PM
Looks real good which Vetric program did you use?

bsimages
12-24-2011, 11:05 PM
Looks real good which Vetric program did you use?

Aspire!

LouF
12-24-2011, 11:40 PM
Thanks it will be some time before I can purchase that I have Cut2D and saving for VCarve Pro..

bsimages
12-25-2011, 12:17 AM
Thanks it will be some time before I can purchase that I have Cut2D and saving for VCarve Pro..

Save your pennies, because it's worth everyone of them!