PDA

View Full Version : RFQ: Aluminum Cavity



Cold Fusion
08-26-2011, 12:27 PM
6061 aluminum
1"x1"x36"
Will drop ship material unless you can source local
No chatter in surface finish
Tolerances aren't critical, .01" is fine.
Use of 1/8" ball mill is acceptable
Quantity: 1
Geometry is finalized


I'm trying to get this done fairly cheaply. Either I can drive three hours to a shop to do it myself, or farm it out. The part is very simple and is a one setup piece. I can even provide the Gcode if you would like.