PDA

View Full Version : Anyone interested in a hobbycnc 4aupcwhc for foam cutter?



planekrazie
08-17-2011, 02:03 PM
Hey guys,
I know I am in the wrong forum for this but its a good place to post this.
I was going to build another hot wire foam cutter but decided to stick with the cnc routers. If anyone is interested I have a hobbycnc 4aupcwhc (this is the one with the heat control on board. Dave at hobbycnc doesnt sell them anymore. what a shame because they are great boards.) Any ways, It comes with a 12v power supply, Beautiful case, Of course the 4aupcwhc, 4 80 oz/in steppers, and a few other odd and ends. check out the pictures. $215.00 paypal only (safer for me and you) Shipped to the USA. Or best offer
If interested Email me or Pm
stevemarsh@automatedwoodworks.com
Thanks Steve

magnetos2010
11-05-2011, 10:40 PM
hi, what software did you use to controll this board. do you still have the setup to controll it . is been 6 years that i am trying to use my cnc foam cutter .. never got to work.